开关柜厂家
贵州高低压开关柜接线与接排工序的检查
您的当前位置: 贵阳开关柜 >> 新闻动态 >> 行业新闻

贵州高低压开关柜接线与接排工序的检查

发布日期:2018-01-19 作者:贵州开关柜 点击:

贵州高低压开关柜接线与接排工序的检查

Inspection of connection and connection process of high and low voltage switchgear in Guizhou

贵州开关柜

关于高低压开关柜质量的检查主要分为两方面内容,一方面是高低压开关柜接线工序的检查,还有一方面则是开关柜接排工序的检查。若是各方面都满足要求的话,说明高低压开关柜的质量

The inspection of the quality of the high and low voltage switchgear is mainly divided into two parts. One is the inspection of the wiring procedure of the high and low voltage switchgear, and the other is the inspection of the switchgear connecting process. If all aspects are satisfied, the quality of the high and low voltage switchgear


是合格的。

It is qualified.


贵州开关柜浅谈首先进行的是高低压开关柜接线工序的检查,先是检查其导线是否连接牢靠,要求每个端子只允许连接一根导线,必要时允许连两条导线;同时穿越金属构件的绝缘导线应有

The switch cabinet in Guizhou is discussed in the first place. The first is to check the wiring process of the high and low voltage switchgear. First it is to check whether the conductor is reliable and connected. It requires that each terminal only allow one conductor to connect, if necessary, allow two wires to be connected. Meanwhile, the insulated conductor passing through the metal component should have a proper connection.


保护导线不受损伤的措施。

Measures to protect the wire from damage.


再要用线束布线,线束要横平竖直,且横向不大于30mm,竖向不大于400mm,应有一个固定点;若是交流回路的导线穿越金属隔板时,该电路所有相线和零线均应从同一孔中穿过。

The wiring harness should be wiring again. The wiring harness must be horizontal and vertical, and the transverse length is not greater than 30mm, and the vertical is not greater than 400mm. There should be a fixed point. If the conductor of the AC circuit passes through the metal diaphragm, all phases and zeros of the circuit should be passed through the same hole.


然后是高低压开关柜接排工序检查,重点是在母排加工质量及其安装质量的检查,母排表面涂层无流痕、应均匀,母排弯曲处不得有裂纹及大于1mm的皱纹,表面应无起皮、锤痕、凹坑、毛

Then the high and low voltage switch cabinet discharging process inspection, the focus is on the bus process quality and check installation quality, no flow marks, busbar surface coating should be uniform, bending at the bus there shall be no crack and more than 1mm of the surface should be no wrinkles, skin, hair, hammer marks, pits


刺等;贵州开关柜小编今天就分享到这里了。

The Guizhou switch cabinet is shared here today.


本文网址:http://www.paschernikeairmaxtailwind.pw/news/215.html

相关标签:贵州开关柜

最近浏览:

2017年六开彩开奖结果